Innova SM 1800W - control mecanic

Plasma Heater Innova SM 1800W - mechanical control

Availability:
Available
Price ( Final purchase price ):
146114 RON
Product code
1016
Price starting from : 200-300 euro
filtrul2BBB : 1500 - 2000 W
: 15 - 20 mp

Name of product: Plasma Heater Innova SM 1800W ;
Model: Mechanical ;
Remote Control: No ;
Heating stages: 1 ;
Heated area: 15-20 square meters ;
Heated surfaces are indicative and are calculated for a height of room a maximum of 2,5 m and a very good thermal insulation .
Radiation temperature: 80-120 degrees Celsius ;
Panel size: 440 * 130 * 40 mm ;
Size: 32 \"(81 cm  );
Weight: 6.5 kg ;
Color: piano black ;
Installation: on the wall mounting included Putty (support + plugs + screws) ;
Power cable included: Yes, length 2 m ;
Power supply: 220V-240V ;
Long-wave infrared: 8 to 14 microns ;
Maximum power: 1800W ;
Average consumption: 0.97 Kwh / hour .
The number of hours of operation may vary between 2-3 hours for apartments and 4-5 hours for houses (in 24 hours) and depends on the degree of insulation of the room, the desired temperature in the room, exterior temperature, etc.
To calculate the exact heat they take into consideration the following elements for each room separately:  

 

  • length\/width\/height (surface\/volume) ;
  • degree of isolation (determined according to the building materials and insulating material used) ;
  •  number of exterior walls of the room;
  • the surface of Windows/doors on each outer wall and their quality;
  • if it is a house or an apartment block;
  • in the case of the apartment block, as it is located in the apartment (ground floor, between floors or floor) and if the surrounding apartments are heated;
  • the degree of insulation of the floor/ceiling (if applicable);
  • If it is heated the entire House or just some rooms;
  • If it is permanent or ocazionala use of housing.

Ask our specialists a heat requirement calculation for each room separately!
Plasma Heater NANO mechanical control with just a button (switch) ON\/OFF (on\/off) and have a single stage heating (equivalent to the maximum power stage of the electronic control).
NANO Plasma Heater is recommended to attach a ambient thermostat for regulating and maintaining the temperature in the room. In this case, the thermostat will interrupt the supply of electricity at fixed temperature. When the room temperature decreases in Plasma Heater NANO will restart in order to maintain the room temperature equal to the temperature currently set (desired).
Ambient thermostat: OPTIONAL.
We put at your disposal the thermostat outlet type 16 A: Thermostats-Thermostat outlet-16-A

 

Ask a question / Write a review (comment)


* Required fields