|filtrul2BBB||: 2000 - 2500 W|
|Price starting from||: 300-400 euro|
Product name: Vertically Thermal Plasma Bofa 2400W ;
Remote Control: NO;
Speed heating: 1;
Heated area: 20-25 sqm;
Heated surfaces are indicative and are calculated for a height of 2.5 m maximum room and a very good degree of thermal insulation.
Radiation temperature: 80-120 degrees Celsius.
Panel size: 1200 * 400 * 40 mm;
Weight: 11 kg;
Color: piano black;
Mounting: wall mounting included PuTTY (support + plugs + screws);
Power cable included: YES, length 2 m;
Power supply: 220V-240V;
Long-wave infrared: 8 to 14 microns;
Maximum power: 2400 W;
Average consumption: 1.78 Kwh
The number of hours of operation may vary between 2-3 hours for apartments and 4-5 hours (24 hours) and depends on the degree of insulation of the room, the desired temperature in the room, outside temperature, etc.
To calculate the exact heat requirements taking into account the following elements for each room separately:
• length/width/height (surface/volume);
• degree of isolation (determined according to the building materials and insulating material used);
• number of exterior walls of the room;
• the surface of the window\/doors on each outer wall and their quality;
• If it is a house or an apartment block;
• in the case of block apartments, is situated the apartment (ground floor, between floors or floor) and if the surrounding apartments are heated;
• the degree of insulation of the floor\/ceiling (if applicable);
• If it is heated the whole House or just some rooms;
• If it is permanent or occasional use of homes.
Ask our specialists a calculation of heat required for each room separately!
NANO Thermal Plasmas with electronic control can operate on 4 stages of heating and are equipped with remote control. Step 4 ensure rapid heating of homes. Once the desired temperature is reached, the Thermal Plasma system NANO can be adjusted to a lower gear for maintaining temperature, or it will automatically start on step 2, which is the step to maintain the temperature in eco mode.
All Plasmas with electronic controls are able to maintain a programming steps of power for a period of 1-2 hours and stopping after the end of that period.
Attention! If the Thermal Plasma NANO with electronic control is off (it is on StandBy mode) in the event of a power failure, when the power returns, it will automatically start on step 2. So if you want to stop the operation of the thermal Plasma Nano with electronic controls it must be decuplata from the power supply.
NANO Thermal Plasma is recommended to attach a ambient thermostat for regulating and maintaining the temperature in the room. In this case, the thermostat will interrupt the supply of electricity at fixed temperature. When the room temperature decreases in Thermal Plasma, NANO will restart in order to maintain the room temperature is equal to the temperature currently set (desired).
Ambient thermostat: OPTIONAL.
We put at your disposal the thermostat Socket 16 of the type: thermostats-Thermostat outlet-16-1031p.
|Price starting from||: 0-500 euro|
|: 0 - 6 mp|
|Price starting from||: 100-200 euro|
|: 0 - 6 mp|
|Price starting from||: 600-700 euro|